Pressure loss is the reduction in pressure associated with water passing through a component. In meter selection it affects the hydraulic margin available for service, especially where supply pressure is limited or demand peaks are significant.

Compare at the same flow

A pressure-loss figure is meaningful only with its test flow and configuration. Compare curves at the operating points relevant to the project, using consistent units. A catalogue value at one flow should not be compared with a competitor value measured at another. Confirm whether the reported loss includes integrated valves or other components.

For a WE RICH product comparison, the LXC DN15–DN50 ultrasonic water meter with valve control combines ultrasonic measurement with remote valve control for residential supply points.

For a WE RICH product comparison, the LXC-D DN50–DN300 ultrasonic bulk water meter addresses larger-diameter water measurement at network and bulk supply points.

Review the whole assembly

Reducers, strainers, valves and fittings also contribute to pressure loss. A favourable meter curve does not guarantee a favourable installation. Consider available upstream pressure and the pressure required downstream under peak demand. The correct assessment uses the system arrangement rather than assigning the entire pressure change to the meter body.

Balance hydraulic and measuring needs

Increasing meter size may reduce loss at a given flow but can change the low-flow measuring range. Check both effects before selecting a larger model. During commissioning, compare pressure under documented flow conditions and inspect for restrictions or installation errors. Keep the pressure assessment separate from accuracy verification: they answer different performance questions.

Practical checklist

  • Ask for a pressure-loss curve.
  • Include valves and accessories.
  • Check available pressure at peak demand.

Frequently asked questions

Does no moving parts mean zero pressure loss?

No. The hydraulic geometry and complete assembly still matter.

Can I compare different units directly?

Convert them consistently before comparing curves or limits.

Is low pressure loss the only selection criterion?

No. Include measuring range, service pressure, installation and intended use.

Related articles

References and technical reading

Product capabilities depend on the model and its documentation. Confirm installation and performance requirements for the project.

Explore the products for this application

Confirm the selected model’s approved flow range, installation conditions and available communications before specifying it. These options support product evaluation; they do not replace site testing.