Electromagnetic meters measure conductive liquids using an electrical signal generated by their movement through a magnetic field. This makes them useful candidates for many water applications, provided the liquid and installation meet the instrument requirements.

From induced voltage to volume

The operating principle follows Faraday’s law. The liquid acts as a moving conductor, and electrodes sense the resulting voltage. The instrument converts its measurement into flow and accumulates volume. There are no rotating measuring parts in this principle. The meter still requires compatible materials, suitable electrical referencing and an appropriate power arrangement.

For a WE RICH product comparison, the LXG electromagnetic water meter offers an electromagnetic measurement option to compare against the project’s fluid and installation requirements.

Check liquid and installation limits

The minimum conductivity depends on the model. Do not assume that every water stream, especially highly purified water, meets it. Confirm liner and electrode suitability for the liquid. Conventional full-pipe instruments need the measuring section filled; placement near high points or draining outlets deserves review. Grounding and bonding arrangements must follow the instrument manual and pipe configuration.

Define the intended service

A process flowmeter, a distribution meter and a billing-approved water meter may have different documentation and interfaces. Define the required flow range, totalizer behaviour and output before choosing a model. During commissioning, compare local readings, remote values and flow direction. Keep calibration evidence separate from claims about legal acceptance for billing.

Practical checklist

  • Measure conductivity for the actual liquid.
  • Review full-pipe and grounding requirements.
  • Specify outputs and totalizer units.

Frequently asked questions

Can it measure every liquid?

No. The liquid must meet conductivity and material-compatibility requirements.

Does it need electricity?

Yes. Available power arrangements vary by model.

Is a process meter automatically a billing meter?

No. Confirm the required approvals and exact intended use.

Related articles

References and technical reading

Product capabilities depend on the model and its documentation. Confirm installation and performance requirements for the project.

Explore the products for this application

Confirm the selected model’s approved flow range, installation conditions and available communications before specifying it. These options support product evaluation; they do not replace site testing.