Intermittent water supply changes the conditions around a meter. Repeated draining and refilling can introduce air, unstable flow and pressure changes. These effects deserve a hydraulic review before a utility chooses a meter or interprets unusual readings.

Understand the installation environment

A meter intended for a full closed pipe should be evaluated in that condition. Air pockets and two-phase flow can disturb the measurement process. The response depends on the sensing technology and design, so broad statements that a technology always measures or always rejects air are unreliable. Request the documented behaviour of the exact model and identify any empty-pipe diagnostic.

For a WE RICH product comparison, the LXC DN15–DN50 ultrasonic water meter with valve control combines ultrasonic measurement with remote valve control for residential supply points.

For a WE RICH product comparison, the LXC-D DN50–DN300 ultrasonic bulk water meter addresses larger-diameter water measurement at network and bulk supply points.

Review the network before replacing equipment

Map high points, storage arrangements, pressure changes and the sequence used to restore supply. Air-release equipment must be selected and located through an appropriate hydraulic design. A meter replacement alone does not correct an unsuitable refill procedure. Coordinate operations staff and installation teams so that field observations can be linked to supply events.

Interpret alarms and readings together

Compare time-stamped readings with supply logs, local register observations and diagnostics. A missing report may indicate a communications problem rather than a measurement problem. An empty-pipe event may explain a temporary interruption but does not quantify unmeasured consumption. Use a representative pilot to observe recovery after refill and define how exceptions will be handled in billing.

Practical checklist

  • Record supply interruptions during the pilot.
  • Ask for documented diagnostic behaviour.
  • Review refill procedures with operations staff.

Frequently asked questions

Can a meter remove air?

A meter is not a substitute for a designed air-management system.

Does an alarm prove incorrect billing?

No. Review the event duration, register data and the billing process before reaching a conclusion.

Is this only an ultrasonic issue?

No. Installation conditions can affect different meter technologies in different ways.

Related articles

References and technical reading

Product capabilities depend on the model and its documentation. Confirm installation and performance requirements for the project.

Explore the products for this application

Confirm the selected model’s approved flow range, installation conditions and available communications before specifying it. These options support product evaluation; they do not replace site testing.